West Coast Time
Terms and Conditions
Cases and Hardware
Road Racks and Cases
DR Series Rack Drawer Tool Cases
> DR002H | Road Case Style 4 Drawer Tool Box
Click to Enlarge
DR002H model shown above with front cover open.
DR002H | Road Case Style 4 Drawer Tool Box
This is the EWI Tourcase tm Model DR002H Series tool case which is a rolling road case with four drawers and a removable, hinged front door.
The DR002H side panels are constructed with 3/8 inch hardwood plywood and covered with a black ABS laminate finish. The aluminum rivets on the 4 recessed padded flip handles are backed with washers to ensure strength and durability. The case rolls on 4 heavy duty 4" swivel casters, two of which are braking style. The casters are shipped un-mounted with all mounting hardware included.
The 4 drawers are mounted to the case with slide rails. The top 3 drawers are 4 1/2" deep and the bottom drawer is 8 1/2" deep. All 4 drawers measure 18 1/8" from front to back and 17 3/8" from left to right on the inside. The drawers are fully padded on the inside with thin close-cell foam.
We now have available "dice cut"
Pick & Pluck foam sheets
cut to fit the DR002H drawers. A single set of foam consists of 2 sheets of pick & pluck and 1 sheet of egg crate foam. Each sheet of foam is 1" thick so the smaller drawers would need four sheets to completely fill them and the large drawer would need eight sheets. You can buy as many sets as you like to customize each drawer.
These are well made, heavy duty job-site tool boxes.
Heavy duty construction
Tough 3/8" plywood and ABS laminate panels
4 drawers mounted on slide rails
Removable front cover
Recessed butterfly latches and padded flip handles
Four 4" swivel casters including two which are locking style
Large steel ball corners
Chrome plated hardware
Portable tool box for job sites.
Type: Heavy duty 4 drawer tool box
Height: 36" (measured on casters)
Front to back: 24" (measured at ball corners)
Left to right: 21 1/2" (measured at ball corners)
Weight: 110 lbs.
Shipping weight: 127 lbs.
Warranty: 3 years covering mfg. defects
PAD25 | Rigid Foam Insert for Various Cases
PPF | Pick & Pluck Foam Sets for Various Cases
Recently Viewed Items