This is the EWI Tourcase
tm Model DR002H-2T Series tool case which is a rolling
road case with four drawers and a removable, hinged front door that
attaches to the case to form a tabletop.The door houses the
steel table legs which fold flat when transporting. The
spring assisted legs fold down and lock into position to form a
tabletop that is 30 1/8" tall. The table attaches to
either side of the case with two heavy duty hooks on the lid and
two brackets on either side of the case.
The
DR002H side
panels are constructed with 3/8 inch hardwood plywood and covered
with a black ABS laminate finish. The stainless steel rivets on the 4 recessed padded flip handles
are backed with washers to ensure strength and durability. The
case rolls on 4 heavy duty 4" swivel casters, two of which are
braking style. The casters are shipped un-mounted with all mounting
hardware included.
The 4 drawers are mounted to the case with slide rails.
The top 3 drawers are 4 1/2" deep and the bottom drawer is 8 1/2" deep. All 4
drawers measure 18" from front to back and 17 1/2" from left to
right on the inside.
The drawers are fully padded on the inside with thin close-cell foam.
We now have available
"dice cut" Pick & Pluck foam sheets cut to fit the DR002H
drawers. A single set of foam consists of 2 sheets of pick & pluck
and 1 sheet of egg crate
foam. Each sheet of foam is 1" thick so the smaller drawers would
need four sheets to completely fill them and the large drawer would
need eight sheets. You can buy as many sets as you like to customize
each drawer.These are well made, heavy duty job-site tool boxes.
Shown
above with door removed.
Series
of photos showing table hook and latch assemblies.
Drawer
above shown with 4 sheets of foam installed.
